A ship has no speedometer and no road. Around it there is only water, and water looks the same at three knots as at ten. For centuries, sailors needed one number to know where they were: how fast the ship was going. Their answer was a piece of wood, a long rope and a thirty-second sand timer, and it left us with a word we still use every day.

Throw a drag overboard and count

The device is called a chip log. It is a wooden board, a quarter circle a few inches across and weighted with lead, tied to a line that is wound on a reel. The board is thrown off the stern. It acts like a drogue: it stays roughly in place in the water while the ship sails away from it, so the line runs out through the sailor's hands. The line has knots tied at uniform intervals. One sailor lets it run, another holds a sandglass, and when the sand finishes he shouts "Belay!" and the knots that passed are counted.

The first description in print comes from William Bourne's A Regiment for the Sea in 1574, which already uses a half-minute sandglass.

Why the knots are where they are

The spacing is a proportion. A knot is one nautical mile per hour, and a sandglass runs for a tiny slice of an hour. If the glass runs 28 seconds, that is 28/3600 of an hour, so the knots must sit 28/3600 of a nautical mile apart. A nautical mile is 1,852 metres, so that gives 14.4 metres, or 47 feet 3 inches. A ship doing one knot lets exactly one knot of line run out in 28 seconds; a ship doing eight lets out eight.

That is why the number of knots counted is the speed. No arithmetic is needed on a heaving deck. Ships used 28-second and 14-second glasses, and knots were commonly spaced about 8 fathoms (48 feet) apart, which suits a glass of 28.8 seconds if you take a mile of 6,000 feet. The mile was not fixed everywhere, which is part of the story below.

stern Knots paid out: 0 Sandglass
Knot spacing on the line
Sandglass
Log reads–
True speed through water–
Over the seabed–

Set a speed, then heave the log. The animation runs the 28 seconds about four times faster than real time.

Try to fool the log

Start with the 47 ft 3 in line and the 28-second glass: the count matches the speed, whatever you set. Now switch to 42 feet and a 30-second glass. Those knots are too close for that glass, so more of them pass and the log reads high, about 20 percent too fast at any speed. Early sailors used a shorter mile, around 5,000 feet, so a 42-foot spacing came from the units of the time, not from carelessness. The trouble is that a log tied to the wrong mile misleads every position afterwards.

Now raise the current slider. The reading does not change. The log measures speed through the water, and a drag riding along in that water cannot tell if the whole sea is moving. Navigators knew this and corrected their position with sightings of land, sun and stars. The log is also not perfect in other ways: a following sea, stretch in the line and a sandglass that runs differently with temperature and humidity all add error. Taking readings often helped, because individual errors averaged out.

From rope to a word

A ship's log was heaved about every half hour. The speeds were written in a book, and from them came the name of the book itself: the logbook. The unit of speed that came out of it is the knot, one nautical mile per hour, and a nautical mile is tied to the Earth itself, roughly one minute of latitude. By the nineteenth century, mechanical taffrail logs trailing a spinning rotor replaced the chip log, but the name stayed, and so did the idea: when you cannot see how fast you are going, drop something behind you and count how much rope you leave.